Body shops and detailers prepping a car for repaint face a specific hazard most correction compounds ignore: silicone-based ingredients — common in many polishes and waxes for the slip and shine they add — can contaminate a panel and cause fisheye defects when new paint is sprayed over it. P6000 SF exists to remove that risk entirely while keeping every performance benefit of the standard formula.

Silicone contamination is the enemy of ceramic coatings, paint protection film, and fresh paintwork. Even trace amounts of silicone can cause fisheye defects that require costly rework. The Pro 6000 SF eliminates this risk entirely. Use it confidently before coating application, PPF installation, or in body shop environments where silicone contamination is prohibited.

P6000 SF still cuts, polishes, and finishes in a single product, with an abrasive system that breaks down progressively through the pass to take a panel from moderately marred to glossy. The difference is purely in the formulation — no silicone-based lubricants or fillers, verified 100% silicone-free, so it's genuinely safe to use on a panel that's heading to the paint booth next.

Removing silicone doesn't mean removing all lubricity or protection — PTFE fills that role in the SF formula, keeping the compound gliding smoothly under the polisher and leaving a light protective layer behind, all without the contamination risk silicone carries.

Between the dust-free application and extended working time, P6000 SF is built to perform in a professional body shop or detailing bay where consistency across multiple vehicles and predictable results matter as much as raw cutting power.

1. Confirm the panel is clean and, if defects are heavy, already cut with P4000

2. Apply a moderate amount to a clean foam polishing pad

3. Work at low speed initially, then at machine speed in overlapping passes

4. Continue until the compound breaks down to a fine, glossy finish

5. Wipe clean with a microfiber towel and inspect under light

6. Proceed to P8000 SF or P9500 SF, or directly to repaint prep as required

• 100% Silicone-Free — Certified with Certificate of Analysis per batch
• 3-in-1 Correction — Cut, polish, and finish controlled by pad selection
• PTFE Enhanced — Fluoropolymer surface protection without silicone
• Body Shop Safe — Zero silicone contamination risk
• Coating & PPF Compatible — Use directly before ceramic coatings or PPF
• Dust-Free, Extended Working Time
• Over 90% biodegradable and natural mineral content